LED density is important in determining the distance between LEDs (pitch) and whether or not there will be visible hotspots and dark spots between the LED emitters. Do not worry too much about this, as what is most important in an LED strip is the number of LEDs per foot, and the power draw per foot. You may come across various LED emitter names such as 2835, 3528, 5050 or 5730. You will also want to watch out for low cost LED strips that claim high brightness, as they may overdrive the LEDs to the point of premature failure. Light output and efficiency per LED emitterĪn LED strip light without a brightness specification in lumens is a red flag. LED strip brightness is primarily determined by three factors: 4-ft T8 fluorescent = 4-ft of LED strip = 1800 lumens). A good quality LED strip should provide at least 450 lumens per foot (1500 lumens per meter), which provides approximately the same amount of light output per foot as a traditional T8 fluorescent lamp. LED strip brightness is typically described in lumens per foot (or meter). Unlike incandescent bulbs, different LED strips can have different levels of efficiency, so a wattage rating is not always meaningful in determining actual light output. Q: Why is the LED strip light remote not working?Ī: There may be many reasons for the failure of the remote control buttons.Brightness of LED strips is determined using the metric lumens. First, you can try to press the OFF button to turn off the remote control, and then press ON to turn it on again. If it still doesn’t work after restarting, try to turn off the light and turn it on again, and reconnect the remote control. If it still doesn’t work after both of the above, it may be because the battery is flat, and that you need to replace the battery. The purchased strip light set will usually come with a spare battery for replacement. If it still doesn’t work after the battery is replaced, it is likely there is a problem with the remote control, and you are recommended to consult the after-sales service of the merchant. LED Light Strip Remote Control Instructions How to Turn on LED Strip Light Without Remote Controller Part 1. Here, we will take the highly popular Lepro RGB LED strip light as an example to show you how to use wireless LED strip lights with remote to adjust the strip light effects.Ħ5.6ft RGB LED Strip Lights with Remote Controller Generally, the remote controllers of different brands and models are not quite the same. Switch on/off: The red button in the upper right corner is meant for turning the remote control on or off. Pause: Press the Pause key to pause the current light mode.īrightness: The two buttons on the upper left corner are meant for adjusting the brightness of the strip light. The button on the left is for increasing brightness (+), and the button on the right is for decreasing brightness (–). Static Mode: Set 20 fixed colors in the Static Mode area. Press any key to adjust the strip light to the corresponding color.ĭIY Mode: You can see buttons from DIY1, DIY2, to DIY6 on the remote control, which means you can set up to six DIY modes. If you want to set the color of DIY1, first press “DIY1,” then press and hold the six up and down arrow keys to adjust the parameters on the RGB palette (RED, GREEN, and BLUE) to set the color that you want. Then, press “DIY1” again to save the chosen color in the DIY1 mode.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |